If you don’t have an outside tap to connect the pressure washer, then a kitchen tap can be your last option to connect it with the cleaning machine. This article has written a step-by-step guide on connecting a pressure washer to a kitchen tap to make the cleaning easier and hassle-free.
To connect a pressure washer to a kitchen tap is not an easy task as they don’t have a kitchen tap thread. There is some pressure washer available in the market that can take water from a bucket with the help of a suction hose. But if your cleaning a surface that requires continuous flow, then read the below guide.
Steps To Connect Pressure Washer To A Kitchen Tap
Now before you are going to connect the machine, you will need
- Hose Pipe
- Universal Tap Connector
Make sure when you are connecting the hose pipe to the kitchen tap, it has a length of 50 feet or more. When you connect it to the outdoor tap, the hose pipe will be small, but if you connect to the indoor tap, then the hose pipe should be longer in length depending on the distance from tap to cleaning machine.
So if you don’t have a hosepipe and looking to buy a new one, measure the distance from the kitchen to the actual location where the machine will be used for cleaning.
Purchase the universal connector for the tap. This connector will be useful in connecting any kitchen tap that is available in different models.
How To Connect a Pressure Washer To a Kitchen Tap
Now after connecting the hose pipe to the machine now connect the kitchen tap to a universal connector. Now turn the tap a little bit to make the water flow slowly and check whether the water is flowing without any leakage. If there is any leakage, reconnect the connector from the water tap properly and make sure the water flows correctly.
When everything is perfect, you have to recheck the water flow, but make sure this time, open the tap in full and check the hose connector didn’t fall off. If it falls, you have to tighten it even more so that it is not unattached from the water tap and makes the kitchen wet.
Connecting Hose Pipe
After placing the connector correctly, it’s time to connect the hosepipe to the connector. If the hosepipe is new, then it might be a little difficult to fit. Now put the hose to another end outside where you want to do the cleaning and start testing water flow.
Now connect the end of the hosepipe to the pressure washer. The connector of the pressure washer is situated either at the back or in the front of the unit. Again test the water flow, but this time you will need the help of someone who can turn on the water tap from inside while you are standing outside holding the pressure washer gun.
If the flow of water comes out perfectly from the cleaning machine at a strong pace, the connection has been set up correctly. And, if the water flow is not right, then it might be due to some leakage between the connection.
Q. My setup has been connected perfectly, but still, I am getting low pressure?
The main reason for getting low pressure is your kitchen tap has a low water flow rate. If you have a longer hosepipe, the pressure will not be higher than the small hosepipe length.
Q. If I don’t have a kitchen tap, what are other alternatives?
If you don’t have a kitchen tap to connect, you can go with a portable pressure washer that does not need any connectivity with any connector.
We hope you will connect the pressure washer to a kitchen tap with the help of a hose pipe and universal connector by reading our above guide. Make sure while setting up the connection, each and everything is connected properly.